RST

 


Opcode

Operand

Description

RST

0 – 7

Restart (Software Interrupts)

 

 

—  The RST instruction jumps the control to one of eight memory locations depending upon the number.

—  These are used as software instructions in a program to transfer program execution to one of the eight locations.

—  Example: RST 3.

Instructions

Restart Address

RST 0

0000 H

RST 1

0008 H

RST 2

0010 H

RST 3

0018 H

RST 4

0020 H

RST 5

0028 H

RST 6

0030 H

RST 7

0038 H


 

Comments

Post a Comment

Popular posts from this blog

MOV

  Opcode Operand Description MOV Rd,Rs Rd,M M, Rs Copy from source to destination.   —    This instruction copies the  contents  of the source  register into   the destination register. —    The  contents  of the source  register are  not   altered. —    If one of the operands is a memory location, its location is specified   by the contents of the HL registers. —    Example:  MOV  B,   C —     MOV  B,   M —    MOV M,   C  
Read more

MVI

  Opcode Operand Description MVI Rd, Data M, Data Move immediate 8-bit     —    The   8-bit   data   is   stored   in   the   destination   register   or  memory.   —    If the   operand   is   a   memory   location,   its   location   is specified  by  the  contents  of the H-L   registers.   —    Example:  MVI A,   57H —     MVI M,   57H
Read more

LXI

  Opcode Operand Description LXI Reg. pair, 16-bit data Load register pair immediate     —    This   instruction   loads   16 -bit   data   in   the   register   pair. —    Example:  LXI H, 2 03 4   H
Read more